HP Brio BA600 - Installing a Memory Module

59
Installing a Memory Module
Installing a Memory Module
1
Remove the cover. Refer to page 44.
2
If you think you can access the memory modules easily, lay the PC on its side so you
can reach in to access the system board.
3
If not, open the side panel to gain access to the system board. Refer to ”Removing
the Side Panel for Easy Access to System Board Components” on page 46.
4
Either remove the module you want to replace or locate an empty memory module
socket.
5
Make sure that the socket’s clips are open.
6
Align the grooves on the bottom of the module with the corresponding marks on
the socket and push it firmly into place. The clips close automatically.
7
Replace the system board if you removed it earlier. Refer to ”Installing a New
System Board” on page 47.
8
Replace the cover. Refer to page 45.
Position of memory
modules
Brio BA400 PC
Brio BA600 PC