50
Replacing a Celeron Processor (BA400 PCs)
Replacing a Celeron Processor (BA400 PCs)
1
Remove the cover. Refer to page 44.
2
Open the side panel of the PC and lay the system board flat. Refer to ”Removing the
Side Panel for Easy Access to System Board Components” on page 46.
3
Unclip and remove the heatsink.
4
Raise the lever to the side of the socket to release the old processor, then lift it out.
5
Install the new processor in the socket, with its corner marker facing the corner
marker on the socket, then lower the lever to lock it in place.
6
Replace the heatsink and fasten the retention clip.
7
Refer to page 47 for instructions on reinstalling the system board in your PC.
8
Replace the PC’s cover. Refer to page 45.
Caution
For your safety, disconnect the power cord and all external cables.
Note
Some Celeron processors may use a slightly different design of heatsink.
➂
➂➂
➂
➂
➂➂
➂
➃
➃➃
➃
➄
➄➄
➄
➅
➅➅
➅
To Next Page
Loading...
