4. If the WLAN antenna is not connected to the terminal on the WLAN module, you must install a protective
sleeve on the antenna connector, as shown in the following illustration.
To install the WLAN module, reverse this procedure.
Solid-state drive
To remove the solid-state drive, use this procedure and illustration.
Table 5-5
Solid-state drive descriptions and part numbers
Description Spare part number
256 GB N24433-001
128 GB N24432-001
Solid-state drive thermal pad N24434-001
Before removing the solid-state drive, follow these steps:
Solid-state drive
31
To Next Page
Loading...
