Security
Hardware and Software Guide 14–14
Setting DriveLock Passwords
To access the DriveLock settings in Computer Setup:
1. Shut down the tablet PC. If you are not sure whether the
tablet PC is off or in hibernation, turn the tablet PC on by
sliding the power button, and then shut down the tablet PC
through the operating system.
2. Be sure that the hard drive is inserted into the tablet PC
(not
into an optional docking device or external MultiBay).
3. Open Computer Setup by turning on the tablet PC. Press f10
while the F10 = ROM Based Setup message is displayed in
the lower-left corner of the screen.
❏ To change the language, press f2.
❏ For navigation instructions, press f1.
4. Use the arrow keys to select Security > DriveLock
passwords. Then press
enter.
5. Select the location of the hard drive, and then press f10.
6. Toggle the Protection field to Enable, and then press f10.
7. Read the warning. To continue, press f10.
8. Type your user password in the New password and Verify
new password fields, and then press
f10.
9. Type your master password in the New password and
Verify
new password fields, and then press f10.
10. To confirm DriveLock protection on the drive you have
selected, type
DriveLock in the confirmation field, and then
press
f10.
11. To save your DriveLock settings, select File > Save changes
and exit. Then follow the instructions on the screen.
Your preferences are set when you exit Computer Setup and take
effect when the tablet PC restarts.
To Next Page
Loading...
Need help?
General
