Fan
Description Spare part number
Fan (includes cable) 693308-001
Before removing the fan, follow these steps:
1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4.
Remove the battery (see
Battery on page 56).
5. Remove the service cover (see
Service cover on page 58).
Remove the fan:
1. Disconnect the fan cable (1) from the system board.
2. Remove the two Phillips PM2.0×3.4 screws (2) that secure the fan to the top cover.
3. Lift the left side of the fan (3) until it rests at an angle, and then remove the fan.
Reverse this procedure to install the fan.
68 Chapter 4 Removal and replacement procedures
To Next Page
Loading...
