Fingerprint reader assembly
Description Spare part number
Fingerprint reader assembly for use in HP EliteBook 745 models (includes cable, bracket, and insulator) 730956-001
Fingerprint reader assembly for use in HP EliteBook 755 models (includes cable, bracket, and insulator) 730817-001
Before removing the fingerprint reader assembly, follow these steps:
1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the following components:
a. Service door (see
Service door on page 47)
b. Battery (see
Battery on page 49)
c. Fan (see
Fan on page 74)
d. Keyboard (see
Keyboard on page 58)
e. Base enclosure (see
Internal base enclosure on page 68)
Remove the fingerprint reader assembly:
1. Turn the computer upside down.
2. Remove plastic cover from the fingerprint reader assembly (1).
3. Slide the bracket away from the fingerprint reader board (2), and remove it.
ENWW Component replacement procedures 83
To Next Page
Loading...
