3. Release the webcam cable and WWAN module antenna cables from the retention clips (3) that are built into
the fan.
4. Disconnect the display panel cable (1) from the system board.
5. Carefully disconnect the WLAN module antenna cables from the WLAN module (2).
NOTE: Computer models have either one or two WLAN module antennas. On models with two antennas,
the #1 white WLAN module antenna cable connects to the WLAN module #1 Main terminal. The #2 black
WLAN module antenna cable connects to the WLAN module #1 Aux terminal.
6. Release the display panel cable from the retention clips (3) that are built into the computer.
7. Release the WLAN module antenna cables from the retention clips (4) that are built into the computer.
Display assembly 61
To Next Page
Loading...
