8. Remove the six Phillips M2.5 × 4.9 screws that secure the display assembly to the computer.
9. Swing the display hinges (1) up and back as far as they will go.
10. Open the display assembly (2) as far as it will open.
11. Separate the computer (3) from the display assembly.
12. If you need to replace the display bezel or the internal display assembly subcomponents:
a. Flex the bottom inside edge (1) of the bezel to release it from the display back cover.
b. Flex the left (2) and right inside edges of the bezel to release it.
c. Flex the top inside edge (3) of the bezel to release it.
d. Remove the bezel (4) from the display back cover.
The bezel is available using the following spare part numbers:
62
Chapter 5Removal and replacement procedures for authorized service provider parts
To Next Page
Loading...
