HP EliteBook 840 G9 - Page 71

f. Disconnect the display panel cable (4) from the display panel.
g. Remove the display panel.
The display panel is available using the following spare part numbers:
● N99947-005: 35.6 cm (14.0 in), LCD, WUXGA (1920 × 1200), antiglare, UWVA, LED, TOP bent
display panel; typical brightness: 250 nits
● N99948-005: 35.6 cm (14.0 in), LCD, WUXGA (1920 × 1200), antiglare, UWVA, WLED + LBL, eDP
1.4 + PSR2, non-TOP bent display panel; typical brightness: 400 nits
● N99949-005: 35.6 cm (14.0 in), LCD, WUXGA (1920 × 1200), antiglare, UWVA, WLED + LBL, sRGB
100, eDP 1.3 + PSR, non-TOP bent display panel; typical brightness: 1000 nits
● N99946-005: 35.6 cm (14.0 in), LCD, WUXGA (1920 × 1200), antiglare, UWVA, WLED + LBL eDP,
non-TOP bent display panel; typical brightness: 400 nits
14. If you need to remove the hinge cover:
a. Remove the display bezel.
b. Remove the display panel.
c. Remove the Phillips M1.3 × 2.5 screw (1) that secures the hinge cover to the display back cover.
d. Slide the hinge cover (2) to the right as far as it will go.
e. Swing the top edge of the hinge cover (3) up and forward, and then remove it (4) from the display back
cover.
The hinge cover is available using spare part number tbd-001.
Display assembly
65