Power on the server
6. Press the Power On/Standby button.
7. Verify that the system power LED changes to green.
8.
Update the following:
•
System ROM
• Storage controller
• Network controller
Set up the storage
9.
Set up the storage. Do one of the following:
• If the drives are connected to the onboard LFF/SFF drive SATA port, set up RAID using the Marvell BIOS
Utility.
• If the drives are connected to an HPE Smart Array controller option, do one of the following:
◦ If the HPE Rapid Setup Software USB drive is shipped with server, set up automatic RAID using the RSS.
◦ Set up RAID using the HPE Smart Storage Administrator. Launch the HPE SSA from an ISO image using one
of the following methods:
– Burn the image to a CD or DVD.
– Flash the image to a USB memory key or SD card on an HPE UEFI bootable server.
– Install the image on a PXE server.
For more information, see HPE Smart Array SR Gen10 Configuration Guide at the Hewlett Packard
Enterprise:
https://www.hpe.com/info/smartstorage-docs
An SSD or optical drive installed in the media bay does not support RAID configuration.
Deploy an OS or virtualization software
10. Install an operating system (OS).
Setup
19
To Next Page
Loading...
