HP FlexFabric 5700 series Configuration Guide

58
Ste
p
Command Remarks
2. Enter VSAN view.
vsan vsan-id N/A
3. Set the minimum LSR
refresh interval.
fspf min-ls-interval value The default setting is 5 seconds.
Setting the FSPF cost for an interface
Each link has a cost. The route selection algorithm uses this value to determine the best route. The smaller
the interface FSPF cost, the smaller the link cost.
To set the FSPF cost for an interface:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter VFC interface view.
interface vfc
interface-number
N/A
3. Set the FSPF cost for the
interface in a VSAN.
fspf cost value vsan vsan-id
The default setting for VFC interfaces are
100.
Setting the hello interval for an interface
The hello interval specifies the time between the hello packets sent periodically by the switch to discover
and maintain neighbor relationships.
NOTE:
The configured hello interval must be smaller than the dead interval and must be the same at the two ends
of the link.
To set the hello interval for an interface:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter VFC interface view.
interface vfc interface-number
N/A
3. Set the hello interval for the
interface in a VSAN.
fspf hello-interval value vsan
vsan-id
The default setting is 20 seconds.
Setting the dead interval for an interface
After two switches establish a neighbor relationship, they send hello packets at the hello interval to each
other to maintain the neighbor relationship. The dead interval specifies the interval during which at least
one hello packet must be received from a neighbor before the neighbor is considered nonexistent and
removed.

HP FlexFabric 5700 series Specifications

General

Layer Support	L2/L3
Routing Protocol	OSPF, BGP, RIP, IS-IS, Static Routing
Remote Management Protocol	SNMP, CLI, Web
Features	VXLAN
Compliant Standards	IEEE 802.1D, 802.1Q, 802.1w, 802.1s, 802.3ad
Operating Temperature	0°C to 45°C
Operating Humidity	10% to 90% (non-condensing)
VLANs	4K