EasyManuals Logo

HP FlexFabric 5700 series Configuration Guide

HP FlexFabric 5700 series
185 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #66 background imageLoading...
Page #66 background image
59
NOTE:
The configured dead interval must be greater than the hello interval and must be the same at the two ends
of the link.
To set the dead interval for an interface:
Ste
p
Command
Remarks
1. Enter system view.
system-view N/A
2. Enter VFC interface view.
interface vfc interface-number
N/A
3. Set the dead interval for the
interface in a VSAN.
fspf dead-interval value vsan
vsan-id
The default setting is 80 seconds.
Setting the LSR retransmission interval for an interface
The LSR retransmission interval specifies the time to wait for an LSR acknowledgment from the neighbor
before retransmitting the LSR.
To set the LSR retransmission interval for an interface:
Ste
p
Command
Remarks
1. Enter system view.
system-view
N/A
2. Enter VFC interface view.
interface vfc interface-number
N/A
3. Set the LSR retransmission
interval for the interface in a
VSAN.
fspf retransmit-interval value
vsan vsan-id
The default setting is 5 seconds.
Disabling FSPF for an interface
With FSPF enabled, an interface can participate in SPF calculation. To avoid SPF calculations on an
interface, disable FSPF on the interface.
To disable FSPF on an interface:
Ste
p
Command
Remarks
1. Enter system view.
system-view N/A
2. Enter VFC interface view.
interface vfc interface-number
N/A
3. Disable FSPF for the interface in
a VSAN.
fspf silent vsan vsan-id
By default, FSPF is enabled on all
interfaces.
Configuring FSPF GR
FSPF graceful restart (GR) enables nonstop forwarding of traffic by backing up FSPF configuration
information in the following situations:
A protocol restart (for example, the FSPF process restart triggered by the process command).

Table of Contents

Other manuals for HP FlexFabric 5700 series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the HP FlexFabric 5700 series and is the answer not in the manual?

HP FlexFabric 5700 series Specifications

General IconGeneral
Layer SupportL2/L3
Routing ProtocolOSPF, BGP, RIP, IS-IS, Static Routing
Remote Management ProtocolSNMP, CLI, Web
FeaturesVXLAN
Compliant StandardsIEEE 802.1D, 802.1Q, 802.1w, 802.1s, 802.3ad
Operating Temperature0°C to 45°C
Operating Humidity10% to 90% (non-condensing)
VLANs4K

Related product manuals