To Next Page

To Previous Page

Please input the file name(*.cfg)[flash:/startup.cfg]

(To leave the existing filename unchanged, press the enter key):

Validating file. Please wait...

Saved the current configuration to mainboard device successfully.

[SwitchA] quit

# Reboot the switch.

<SwitchA> reboot

Start to check configuration with next startup configuration file, please

wait.........DONE!

This command will reboot the device. Continue? [Y/N]:y

Now rebooting, please wait...

# Configure the switch to operate in FCF mode.

<SwitchA> system-view

[SwitchA] fcoe-mode fcf

# Enable the enhanced zoning mode in VSAN 1.

[SwitchA] vsan 1

[SwitchA-vsan1] zone mode enhanced

The zoning database in this switch would be distributed throughout the fabric. Continue?

[Y/N]:y

# Create a zone alias named Alias1.

[SwitchA-vsan1] zone-alias name Alias1

# Add pWWN 22:33:44:55:66:77:88:99 (Disk B) and FC ID 020004 (Disk C) as its target members.

[SwitchA-vsan1-zone-alias-Alias1] member pwwn 22:33:44:55:66:77:88:99 target

[SwitchA-vsan1-zone-alias-Alias1] member fcid 020004 target

[SwitchA-vsan1-zone-alias-Alias1] quit

# Create a zone named Zone1, and specify FC ID 010001 as its member.

[SwitchA-vsan1] zone name Zone1

[SwitchA-vsan1-zone-Zone1] member fcid 010001

[SwitchA-vsan1-zone-Zone1] quit

# Create a zone named Zone2, and enable the Pairwise feature for Zone2.

[SwitchA-vsan1] zone name Zone2

[SwitchA-vsan1-zone-Zone2] pairwise-zoning enable

# Specify FC ID 010002 and pWWN 11:22:33:44:55:66:77:88 as its initiator member and target

member, respectively.

[SwitchA-vsan1-zone-Zone2] member fcid 010002 initiator

[SwitchA-vsan1-zone-Zone2] member pwwn 11:22:33:44:55:66:77:88 target

# Add the zone alias Alias1 to Zone2 as a member.

[SwitchA-vsan1-zone-Zone2] member zone-alias Alias1

[SwitchA-vsan1-zone-Zone2] quit

# Create a zone named Zone3, and enable the Pairwise feature for Zone3.

[SwitchA-vsan1] zone name Zone3

[SwitchA-vsan1-zone-Zone3] pairwise-zoning enable

# Specify FC ID 010003 as its initiator member.

[SwitchA-vsan1-zone-Zone3] member fcid 010003 initiator

Other manuals for HP FlexFabric 5700 series

Security Configuration Guide460 pages

Questions and Answers:

Need help?

Do you have a question about the HP FlexFabric 5700 series and is the answer not in the manual?

HP FlexFabric 5700 series Specifications

General

Layer Support	L2/L3
Routing Protocol	OSPF, BGP, RIP, IS-IS, Static Routing
Remote Management Protocol	SNMP, CLI, Web
Features	VXLAN
Compliant Standards	IEEE 802.1D, 802.1Q, 802.1w, 802.1s, 802.3ad
Operating Temperature	0°C to 45°C
Operating Humidity	10% to 90% (non-condensing)
VLANs	4K