To Next Page

To Previous Page

[Device] vlan 1

[Device-vlan1] port ten-gigabitethernet 1/0/2

[Device-vlan1] quit

[Device] vlan 10

[Device-vlan10] port ten-gigabitethernet 1/0/1

[Device-vlan10] quit

[Device] vlan 2

[Device-vlan2] port ten-gigabitethernet 1/0/4

[Device-vlan2] quit

[Device] vlan 5

[Device-vlan5] port ten-gigabitethernet 1/0/3

[Device-vlan5] quit

4. Configure a RADIUS scheme on the access device:

# Create RADIUS scheme 2000 and enter RADIUS scheme view.

[Device] radius scheme 2000

# Specify the server at 10.11.1.1 as the primary authentication server, and set the authentication

port to 1812.

[Device-radius-2000] primary authentication 10.11.1.1 1812

# Specify the server at 10.11.1.1 as the primary accounting server, and set the accounting port to

1813.

[Device-radius-2000] primary accounting 10.11.1.1 1813

# Set the shared key to abc in plain text for secure communication between the authentication

server and the device.

[Device-radius-2000] key authentication simple abc

# Set the shared key to abc in plain text for secure communication between the accounting server

and the device.

[Device-radius-2000] key accounting simple abc

# Exclude the ISP domain name from the usernames sent to the RADIUS server.

[Device-radius-2000] user-name-format without-domain

[Device-radius-2000] quit

5. Configure an ISP domain:

# Create ISP domain bbb and enter ISP domain view.

[Device] domain bbb

# Apply RADIUS scheme 2000 to the ISP domain for authentication, authorization, and

accounting.

[Device-isp-bbb] authentication lan-access radius-scheme 2000

[Device-isp-bbb] authorization lan-access radius-scheme 2000

[Device-isp-bbb] accounting lan-access radius-scheme 2000

[Device-isp-bbb] quit

6. Configure 802.1X on the access device:

# Enable 802.1X on port Ten-GigabitEthernet 1/0/2.

[Device] interface ten-gigabitethernet 1/0/2

[Device-Ten-GigabitEthernet1/0/2] dot1x

# Implement port-based access control on the port.

[Device-Ten-GigabitEthernet1/0/2] dot1x port-method portbased

# Set the port authorization mode to auto. By default, the port uses the auto mode.

Other manuals for HP FlexFabric 5700 series

Configuration Guide185 pages

Questions and Answers:

Need help?

Do you have a question about the HP FlexFabric 5700 series and is the answer not in the manual?

HP FlexFabric 5700 series Specifications

General

Layer Support	L2/L3
Routing Protocol	OSPF, BGP, RIP, IS-IS, Static Routing
Remote Management Protocol	SNMP, CLI, Web
Features	VXLAN
Compliant Standards	IEEE 802.1D, 802.1Q, 802.1w, 802.1s, 802.3ad
Operating Temperature	0°C to 45°C
Operating Humidity	10% to 90% (non-condensing)
VLANs	4K