HP FlexFabric 5700 series User Manual

15
No. Attribute Descri
p
tion
61 NAS-Port-Type
Type of the physical port of the NAS that is authenticating the user. Possible
values include:
• 15—Ethernet.
• 16—Any type of ADSL.
• 17—Cable. (With cable for cable TV.)
• 19—WLAN-IEEE 802.11.
• 201—VLAN.
• 202—ATM.
If the port is an ATM or Ethernet one and VLANs are implemented on it, the
value of this attribute is 201.
79 EAP-Message
Used to encapsulate EAP packets to allow RADIUS to support EAP
authentication.
80 Message-Authenticator
Used for authentication and verification of authentication packets to
prevent spoofing Access-Requests. This attribute is present when EAP
authentication is used.
87 NAS-Port-Id String for describing the port of the NAS that is authenticating the user.
HP proprietary RADIUS sub-attributes
No. Sub-attribute Descri
p
tion
1 Input-Peak-Rate Peak rate in the direction from the user to the NAS, in bps.
2 Input-Average-Rate Average rate in the direction from the user to the NAS, in bps.
3 Input-Basic-Rate Basic rate in the direction from the user to the NAS, in bps.
4 Output-Peak-Rate Peak rate in the direction from the NAS to the user, in bps.
5 Output-Average-Rate Average rate in the direction from the NAS to the user, in bps.
6 Output-Basic-Rate Basic rate in the direction from the NAS to the user, in bps.
15 Remanent_Volume
Total remaining available traffic for the connection, in different units for
different server types.
20 Command
Operation for the session, used for session control. Possible values
include:
• 1—Trigger-Request.
• 2—Terminate-Request.
• 3—SetPolicy.
• 4—Result.
• 5—PortalClear.
24 Control_Identifier
Identification for retransmitted packets. For retransmitted packets from
the same session, this attribute must be the same value. For retransmitted
packets from different sessions, this attribute does not have to be the
same value. The client response of a retransmitted packet must also
include this attribute and the value of this attribute must be the same.
For Accounting-Request packets of the start, stop, and interim update
types, the Control_Identifier attribute does not take effect.
25 Result_Code
Result of the Trigger-Request or SetPolicy operation, zero for success and
any other value for failure.

HP FlexFabric 5700 series Specifications

General

Brand	HP
Model	FlexFabric 5700 series
Category	Switch
Language	English