HP FlexFabric 5700 series User Manual

263
Ste
p
Command Remarks
2. Create an IPsec policy
template and enter its view.
ipsec { ipv6-policy-template |
policy-template } template-name
seq-number
By default, no IPsec policy template
exists.
3. (Optional.) Configure a
description for the IPsec policy
template.
description text
By default, no description is
configured.
4. (Optional.) Specify an ACL for
the IPsec policy template.
security acl [ ipv6 ] { acl-number |
name acl-name } [ aggregation |
per-host ]
By default, no ACL is specified for
the IPsec policy template.
An IPsec policy template can
reference only one ACL.
5. Specify the IPsec transform
sets for the IPsec policy
template to reference.
transform-set
transform-set-name&<1-6>
By default, the IPsec policy
template references no IPsec
transform set.
6. Specify the IKE profile for the
IPsec policy template to
reference.
ike-profile profile-name
By default, the IPsec policy
template references no IKE profile.
An IPsec policy template can
reference only one IKE profile and
it cannot reference any IKE profile
that is already referenced by
another IPsec policy template or
IPsec policy.
For more information about IKE
profiles, see "Configuring IKE."
7. (Optional.) Specify the local
IP address of the IPsec tunnel.
local-address { ipv4-address | ipv6
ipv6-address }
By default, the local IPv4 address
of IPsec tunnel is the primary IPv4
address of the interface to which
the IPsec policy is applied, and the
local IPv6 address of the IPsec
tunnel is the first IPv6 address of the
interface to which the IPsec policy
is applied.
The local IP address specified by
this command must be the same as
the IP address used as the local IKE
identity.
8. (Optional.) Specify the remote
IP address of the IPsec tunnel.
remote-address { [ ipv6 ]
host-name | ipv4-address | ipv6
ipv6-address }
By default, the remote IP address of
the IPsec tunnel is not specified.
9. Configure the IPsec SA
lifetime.
sa duration { time-based seconds |
traffic-based kilobytes }
By default, the global SA lifetime
settings are used.
10. (Optional.) Set the IPsec SA
idle timeout.
sa idle-time seconds
By default, the global SA idle
timeout is used.
11. Return to system view.
quit N/A
12. Configure the global SA
lifetime.
ipsec sa global-duration
{ time-based seconds |
traffic-based kilobytes }
By default, time-based SA lifetime
is 3600 seconds, and traffic-based
SA lifetime is 1843200 kilobytes.

HP FlexFabric 5700 series Specifications

General

Brand	HP
Model	FlexFabric 5700 series
Category	Switch
Language	English