EasyManuals Logo

HP FlexFabric 5700 series User Manual

HP FlexFabric 5700 series
460 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #42 background imageLoading...
Page #42 background image
30
To set RADIUS timers:
Ste
Command
Remarks
1. Enter system view.
system-view N/A
2. Enter RADIUS scheme view.
radius scheme
radius-scheme-name
N/A
3. Set the RADIUS server
response timeout timer.
timer response-timeout seconds The default setting is 3 seconds.
4. Set the quiet timer for the
servers.
timer quiet minutes The default setting is 5 minutes.
5. Set the real-time accounting
timer.
timer realtime-accounting minutes The default setting is 12 minutes.
Configuring the accounting-on feature
When the accounting-on feature is enabled, the device automatically sends an accounting-on packet to
the RADIUS server after a reboot. Upon receiving the accounting-on packet, the RADIUS server logs out
all online users so they can log in again through the device. Without this feature, users cannot log in
again after the reboot, because the RADIUS server considers them to come online.
You can configure the interval for which the device waits to resend the accounting-on packet and the
maximum number of retries.
To configure the accounting-on feature for a RADIUS scheme:
Ste
Command
Remarks
1. Enter system view.
system-view N/A
2. Enter RADIUS scheme view.
radius scheme
radius-scheme-name
N/A
3. Enable accounting-on.
accounting-on enable [ interval
seconds | send send-times ] *
By default, the accounting-on
feature is disabled.
Configuring the IP addresses of the security policy servers
The NAS verifies the validity of received control packets and accepts only control packets from known
servers. To use a security policy server that is independent of the AAA servers, configure the IP address
of the security policy server on the NAS.
The security policy server is the management and control center of the HP EAD solution. To implement all
EAD functions, configure both the IP address of the security policy server and that of the IMC Platform on
the NAS.
To configure the IP address of a security policy server for a scheme:
Ste
Command
Remarks
1. Enter system view.
system-view N/A
2. Enter RADIUS scheme
view.
radius scheme radius-scheme-name N/A

Table of Contents

Other manuals for HP FlexFabric 5700 series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the HP FlexFabric 5700 series and is the answer not in the manual?

HP FlexFabric 5700 series Specifications

General IconGeneral
Layer SupportL2/L3
Routing ProtocolOSPF, BGP, RIP, IS-IS, Static Routing
Remote Management ProtocolSNMP, CLI, Web
FeaturesVXLAN
Compliant StandardsIEEE 802.1D, 802.1Q, 802.1w, 802.1s, 802.3ad
Operating Temperature0°C to 45°C
Operating Humidity10% to 90% (non-condensing)
VLANs4K

Related product manuals