HP HPE FlexFabric 5930 - Appendix B Frus and Compatibility Matrixes; Power Supplies

50
Appendix B FRUs and compatibility
matrixes
Table 10 Compatibility matrix between the FRUs and HPE FlexFabric 5930 switches
FRUs
HPE 5930-32
QSFP+/HPE
5930-32 QSFP+
TAA
HPE
5930-2Slot+2QSFP+/HPE
5930-2Slot+2QSFP+ TAA
HPE
5930-4Slot/HPE
5930-4Slot TAA
Power supplies
650W AC Yes Yes Yes
650W DC Yes Yes Yes
Fan trays
LSWM1HFANSC Yes Yes No
LSWM1HFANSCB Yes Yes No
LSWM1BFANSC No No Yes
LSWM1BFANSCB No No Yes
Interface modules
LSWM18QC No Yes Yes
LSWM124XGT2Q No Yes Yes
LSWM124XG2Q No Yes Yes
LSWM124XG2QL No Yes Yes
LSWM124XG2QFC No Yes Yes
IMPORTANT:
• The HPE 5930-32 QSFP+/HPE 5930-32 QSFP+ TAA/HPE 5930-2Slot+2QSFP+/HPE
5930-2Slot+2QSFP+ TAA switches can operate correctly with only one power supply. You can
install two power supplies on the switches for 1+1 redundancy.
• The HPE 5930-4Slot/HPE 5930-4Slot TAA switch can operate correctly with two power supplies.
You can install four power supplies on the switches for 2+2 redundancy.
• You must install two fan trays of the same model for the switch.
Power supplies
CAUTION:
When the switch has power supplies in redundancy, you can replace a power supply without
powering off the switch. Make sure the power supply to be replaced is powered off before you
replace it.