A Utilities
Configuring a Smart Array Controller
Using the saupdate command
The saupdate command is used to query or change the mode of the Smart Array P410i and
Smart Array P411 controllers to HBA or RAID. Querying or changing modes is not supported for
other controllers.
The following are the newly added commands to saupdate:
• get_mode
• set_mode
get_mode
This command displays the current mode of the controllers.
Syntax
saupdate get_mode <controller>
<controller> can be any one of the strings listed in Table 14.
Table 14 <controller> strings
Meaning
<controller>
A controller having the PCI segment id, bus id, device id
and function id is addressed
<seg:bus:dev:func>
Addresses all controllers in the systemall
Controllers of a particular type indicated by the <model>
string are addressed
<model>
Configuring a Smart Array Controller 133
To Next Page
Loading...
Need help?
General