Rack options 6
o
Install the left casters on the left side of the rack when facing the front of the rack.
2. Place the backing plate inside the rack with the nuts facing the interior of the rack. The alignment
pins protrude from the hole you used to access the screws that mounted the rack to the pallet, and
the backing plate is snug against the sheet metal.
3. From the outside of the rack, position the mounting plate so that the holes closest to the edge are:
o Toward the right side of the rack for the right casters.
o Toward the left side of the rack for the left casters.
4. Place the mounting plate against the rack so the mounting screw holes line up in the center of the
plates and the alignment pins insert into the holes that are off center.
5. Position the caster support against the mounting plate.
6. Install and tighten the two mounting screws.
7. Slide the caster assembly threaded block into the caster support opening.
8. Align the holes, and then insert the two caster support bolts.
9. Install and tighten the two hex nuts onto the caster support bolts.
To Next Page
Loading...
Need help?
General