Enclosure options 27
• Washer
• Bracket assembly screws (12)
Installing the Seismic Rack Mounting Kit
1. Attach the rear brackets to the MSA2324 Carrier-Grade CG
2. Attach the left bracket assembly to the left rack rail.
3. Attach the right bracket assembly to the left right rail.
4. Insert cage nuts into the rack holes.
5. Align the MSA2324 CG with the rails, and then slide it into the rack until the ears of the MSA2324
CG are about 1 to 2 inches from the rack front rails.
6. Attach a flat washer between the right mounting ear (bottom hole) and the rack, and then loosely
attach the bracket to the rear bracket assemblies.
To Next Page
Loading...
