• To enable events, click the Event service enabled toggle button.
• To set the number of retry attempts, enter the number in the Retry attempts box.
• To set the retry interval, enter the number of seconds in the Retry intervals (in seconds) box.
2. Click Add subscription.
3. Type the subscriber’s name in the Name box.
4. Select the Retry policy to use if the original eventlog cannot be delivered.
• Retry forever
• Suspend retries
• Terminate after retries
5. Enter the destination (such as the IP address or DNS) for the system log in the Destination box.
6. To add an HTTP header that passes additional context and metadata about the HTTP request or response, click Http
Headers, and then enter the header information in the format Header Name:Header Value.
• To save an HTTP header, click the green checkmark.
• To delete an HTTP header, click the red X.
7.
Click Save.
Adding drive namespaces
Prerequisites
The user that has Administrator or Operator privileges, is logged into the WebUI.
Procedure
1.
Click the DRIVES tab and select an enabled drive.
2.
Click Add namespace.
3.
Type the drive capacity in bytes up to the total available space.
4.
Click Save.
Adding hosts
Prerequisites
Requires Administrator or Operator privileges
Procedure
1. Click the HOSTS tab, then click Add.
2. Enter the host details, for Host name and NQN on the slide over panel.
Operation
11
To Next Page
Loading...
