Color Drive status
Red Critical
Yellow Warning
Green Good
Gray Not installed
White Disabled
HOSTS tab
The HOSTS tab enables you to view information about and manage hosts (add, remove, edit). You can access the disks
that utilize the NVMe-oF
™
bridge adapter through the WebUI.
IOMS tab
The IOMS tab displays information about and a visual representation of each I/O module. You can also change IOM
network settings such as host name, FQDN, DHCP
on/o toggle, nameservers, IP address, netmask, gateway, and IOM
reset on this page. To illuminate the blue identify LED on the front of the IOM, slide the Locate toggle to the right (ON).
BRIDGES tab
Bridges are the NVMe-oF bridge adapter cards. Each bridge has its own IP address. The bridge settings must be
compatible with the high-speed Ethernet switch settings.
The BRIDGES tab enables you to add bridges for each I/O module or edit bridge settings. It displays up to three Ethernet
bridge adapter cards. System administrators can set up hosts and connect the NVMe-oF bridge adapter card(s) to a
target NVMe Qualified Name (NQN) for each drive.
INVENTORY tab
The INVENTORY tab provides the serial number, model, name, part number, and state for each installed component.
Selecting a component from the list navigates you to the appropriate tab location in the WebUI to obtain more detailed
information. Choose the appropriate check box to filter the results by component status (OK, Warning, and Critical).
Administrator tasks
Access the Administrator tasks by clicking Admin then clicking Admin dashboard in the upper-right area of the WebUI.
Access to functionality is based on your user privilege level.
• Adding users
• Setting the system time
•
Updating firmware
• Viewing logs
• Setting up system alerts
Adding users
Each user is assigned a role within the organization. The available predefined roles follow:
Operation
7
To Next Page
Loading...
