HP J2000 - Securing the Cable Management Arm

6. Push the power module into the J2000 until the power module release tab engages.
7. Pull the finger handle outward slightly to verify that the power module is locked in place.
8. If you can remove the power module from the J2000 without pushing the power module release tab, remove the
power module, repeat steps 5 through 7, and then retest the installation.
9. Choose from one of the following options:
• If replacing one power module:
a. Plug the power cord into the power module jack.
• If replacing both power modules at the same time (system power is o):
a. Repeat steps 2 through 8 to replace the second power module.
b. Plug both cords into both power module jacks.
The system boots after you plug the power cord into the jack.
• If replacing both power modules one at a time (system power is on):
a. Plug in the first power module jack, and then follow steps 2 through 10 to replace the second power module.
10.
Secure the cable management arm - see Securing the cable management arm.
Securing the cable management arm
Prerequisites
You have completed the service actions for the power modules or I/O modules.
Procedure
1.
Gently swing the CMA arm forward to the CMA body rail.
2.
Slide the CMA body connector onto the CMA body rail connector.
Maintenance
22