HP J2000 - Viewing and Downloading Logs; Setting up System Events

Procedure
1. Select the FIRMWARE tab from the Admin Dashboard.
2. Under Upload new firmware, click Choose file, and then select the appropriate firmware file.
A list of targets as determined by the firmware contained in the file is displayed. Possible targets include I/O modules,
bridges, and the WebUI.
3. Select the target to update and click Apply.
The firmware is applied, but the target must be restarted manually to run the new firmware.
4. Click the target to restart it.
NOTE: Select Restart local manager # last. Restarting a target results in a brief interruption to I/O flow. Allow partner
devices to restart completely to avoid disruption to hosts. After all devices are restarted, you can navigate away from
the FIRMWARE tab. Verify that the devices are updated by logging out, logging back in, and navigating to the
FIRMWARE tab again.
Viewing and downloading logs
Prerequisites
All users can view audits and events.
Downloading logs requires Administrator privileges.
Procedure
1.
Select the LOGS tab from the Admin Dashboard.
2.
On the Admin Dashboard, click the LOGS tab.
The logs include audits and events, and display the time stamps, associated input/output module (IOM), and message.
System status indicators are also displayed.
3.
Narrow the results by using the Audit, Event and Severity check boxes.
4.
To download logs, click Download logs and save the .tgz file (TAR Archive file) to a local folder.
Setting up system events
System events are recorded in the system log and users can subscribe to receive alerts whenever a logged event occurs.
Prerequisites
Requires Administrator or Operator privileges
Procedure
1. On the Admin Dashboard, click the EVENTS tab.
Operation
10