4-67
Web and MAC Authentication
Configuring MAC Authentication on the Switch
Figure 4-42. Example of show port-access mac-based clients detail Command Output
Syntax: show port-access mac-based clients <port-list> detailed
Displays detailed information on the status of MAC-
authenticated client sessions on specified ports. Show
session status, name, and address for each MAC-
authenticated client on the switch. The IP address displayed
is taken from the DHCP binding table (learned through
DHCP snooping).The following can appear if the client’s IP
address is not available:
n/a—DHCP snooping is not enabled on the switch; n/a is
displayed for a client’s IP address.
n/a-IPv6—a web-authenticated client uses an IPv6 address.
n/a-no info—DHCP snooping is enabled but no MAC-to-IP
address binding for a client is found in the DHCP binding
table.
HP Switch (config)# show port-access mac-based clients 1 detailed
Port Access MAC-Based Client Status Detailed
Client Base Details :
Port : 1
Session Status : authenticated Session Time(sec) : 6
Username : client1 MAC Address : 0010b5-891a9e
IP : n/a
Access Policy Details :
COS Map : 12345678 In Limit % : 98
Untagged VLAN : 4006 Out Limit % : 100
Tagged VLANs : 1, 3, 5, 6, 334, 4001
RADIUS-ACL List :
deny in udp from any to 10.2.8.233 CNT
Hit Count: 0
permit in udp from any to 10.2.8.233 CNT
Hit Count: 0
deny in tcp from any to 10.2.8.233 CNT
Hit Count: 0
permit in tcp from any to 10.2.8.233 CNT
Hit Count: 0
permit in tcp from any to 0.0.0.0/0 CNT
Hit Count: 0
To Next Page
Loading...
Need help?
General
