5-8
TACACS+ Authentication
Configuring TACACS+ on the Switch
CLI Commands Described in this Section
Viewing the Switch’s Current Authentication
Configuration
This command lists the number of login attempts the switch allows in a single
login session, and the primary/secondary access methods configured for each
type of access.
Syntax:
show authentication
This example shows the default authentication configuration.
Figure 5-2. Example Listing of the Switch’s Authentication Configuration
Command Page
show authentication 5-8
show tacacs 5-9
aaa authentication 5-10 through 5-16
console
Telnet
num-attempts <1-10 >
tacacs-server 5-17
host < ip-addr >5-17
key 5-22
timeout < 1-255 > 5-23
Configuration for login and enable access
to the switch through the switch console
port.
Configuration for login and enable access
to the switch through Telnet.
To Next Page
Loading...
