HP Jetdirect 610N - Page 19

Installing the Print Server 2-19
ENWW
Figure 2-2 Example of HP Jetdirect Configuration Page
3. If I/O CARD READY appears, the card has been installed
successfully. Proceed to “Step 6
. Configure the Card with
Network Parameters Required for Your Network.”
4. If I/O CARD READY does not appear, check that you have:
■ Installed the card correctly and properly connected the card
to the network
■
Verified that the network is operating properly
■
Turned the printer off and then on again
(600N)
I/O CARD READY
(615N/610N)
I/O CARD READY