Memory modules
The computer comes with at least one small outline, dual in-line memory module (SODIMM). To achieve
maximum memory support, you can populate the system board with up to 32 GB of memory.
Memory module specications
For proper system operation, the memory modules must meet the following qualications:
Component Specication
Memory modules 1.2 volt DDR4-SDRAM memory modules
Compliance Unbuered non-ECC PC4-17000 DDR4-2133 MHz-compliant
Pins Industry-standard 260-pin containing the mandatory Joint Electronic Device Engineering
Council (JEDEC) specication
Support CAS latency 15 DDR4 2400 MHz (15-15-15 timing)
Slots 2
Maximum Memory 32 GB
Supported 2 Gbit, 4 Gbit, 8 Gbit, and 16 Gbit non-ECC memory technologies single-sided and double-
sided memory modules
NOTE: The system does not operate properly if you install unsupported memory modules. Memory modules constructed with x8 and
x16 DDR devices are supported; memory modules constructed with x4 SDRAM are not supported.
HP oers upgrade memory for this computer and advises that the consumer purchase it to avoid
compatibility issues with unsupported third-party memory.
Removing memory modules
For a list of available memory modules, see Computer major components on page 3.
There are two memory module slots on the system board, with one slot per channel. The sockets are labeled
DIMM1 and DIMM3. The DIMM1 slot operates in memory channel B. The DIMM3 slot operates in memory
channel A.
Memory modules 27
To Next Page
Loading...
Need help?
General