Table 6 Drive Status (continued)
DescriptionDisplayed in the CLI or SMUStatus
The drive is used in a Vdisk or disk
group.
Vdisk or disk groupVdisk or disk group
The drive is a spare assigned to a
Vdisk or disk group.
Vdisk or disk group SPVdisk or disk group Spare
Disk Drive Leftover
Table 7 Hard disk drive leftover scenarios
Action RequiredCauseSymptom
Check if any Vdisks or disk groups are
OFFL; if disks are offline, see “Using
Due to MEDIUM/SMART/PROTOCOL/
I/O TIMEOUT errors.
A disk drive is marked as LEFTOVR
the Trust Command” (page 26). If all
Vdisks or disk groups are online,
consider replacing the disk drive as an
option to resolve the issue.
Attempt to dequarantine the Vdisk or
disk group by reseating the last failed
A spare disk is used and
reconstruction begins. Before the
A disk drive in a redundant Vdisk or
disk group (in this scenario, other
drives. If unable to dequarantine thereconstruction completes, if anotherthan RAID 6) fails and is marked as
Vdisk or disk group, see“Using the
Trust Command” (page 26).
disk drive from the same Vdisk or disk
group (same sub-Vdisk or subgroup
LEFTOVR and the Vdisk or disk
group status is CRIT
in RAID 10 or RAID 50) fails, the
status of the second failed disk drive
along with the spare disk is marked
as LEFTOVR. The Vdisk or disk
group is OFFL or QTOF (quarantined
offline).
Consider replacing the drives if the
drives failed due to hardware issues.
Vdisk or disk group status is FTDN,
a spare is invoked, and reconstruction
A disk drive in a RAID 6 Vdisk or disk
group (with 1 spare) fails and is
marked as LEFTOVR. If the Vdisk or disk group go QTOFbegins. Before the reconstruction
NOTE: In cases where two/multiple
spares are available and a drive fails,
the drive is marked as LEFTOVR and
the Vdisk or disk group is FTDN. A
spare is invoked and reconstruction
begins. If another member of the
same Vdisk or disk group fails before
the reconstruction completes, the
spare for the second failed drive is
not invoked despite available multiple
spares. Once the status of the Vdisk
or disk group changes to FTDN,
another spare is invoked for this
Vdisk or disk group and
reconstruction begins.
after the failure of a third Vdisk or disk
group member and before the
reconstruction completes, attempt to
dequarantine the Vdisk or disk group
by reseating the last failed drives. If
unable to dequarantine the Vdisk or
disk group, consider “Using the Trust
Command” (page 26).
completes, if another member of the
same Vdisk or disk group fails, its
status is marked as LEFTOVR and
the Vdisk or disk group status is
CRIT. The reconstruction for the first
failed drive does not stop but
continues to completion. Once the
reconstruction completes, the status
of the Vdisk or disk group is back to
FTDN.
Disk Drives 15
To Next Page
Loading...
