EasyManua.ls Logo

HP MSA 2040 - Management Controller Issue; Restarting the Management Controller

HP MSA 2040
30 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
AnswerQuestion
NOTE: Avoid using the manual de-quarantine option
as it takes the Vdisk or disk group OFFL, which causes
data loss.
group is quarantined. Will the expansion continue once
the disk drives return and the Vdisk or disk group
de-quarantines?
No, the spare is not used and the reconstruction does not
begin immediately after the drive fails. Reconstruction
During the expansion of a Vdisk or disk group (other than
RAID 6), if a drive fails making the Vdisk or disk group
begins only after the completion of the expansion. ACRIT and a spare is available can a reconstruction
happen? backup is recommended in case there is further drive
failures.
Two drive reconstructions are performed after the
expansion completes. A backup is recommended in case
there is further drive failures.
During RAID 6 Vdisk or disk group expansion if two drives
fail, can it do two drive reconstruction?
Yes, backup of a Vdisk or disk group is performed during
Vdisk or disk group expansion.
Is it possible to create a backup of a Vdisk or disk group
while an expansion is underway?
NOTE: Best practice is to perform a backup of the data
before initiating the expansion of a Vdisk or disk group.
Trust cannot be performed if a Vdisk or disk group go
OFFL during Vdisk or disk group expansion. Expansion
During a Vdisk or disk group expansion, if the Vdisk or
disk group go OFFL, can we use TRUST to bring the
is aborted and any data on the Vdisk or disk group is
irrevocably lost.
Vdisk or disk group online? If so will the expansion then
proceed?
Yes, Vdisk or disk group expansion continues after the
Vdisk or disk group is failed over to the partner controller.
During a Vdisk or disk group expansion, if the controller
owning the Vdisk or disk group crashes, will the expansion
continue after the Vdisk or disk group is failed over to the
partner controller?
We can create a secondary volume and snapshots are
created for a Vdisk or disk group under expansion.
Can we create a secondary volume and create snapshots
of a volume that is a member of a Vdisk or disk group
All the other activities work fine.
under expansion? What about other activities like
replication?
Yes, the volumes can be remapped.Can the volumes of an expanding Vdisk or disk group be
remapped to different hosts?
For information on replacing the drive modules, see HPE MSA2000/P2000 Drive Module
Replacement Instructions Guide on the Hewlett Packard Enterprise Support Center website.
Management Controller Issue
“Restarting the Management Controller” (page 20)
“Instances when the Management Controller becomes Unresponsive” (page 22)
Restarting the Management Controller
The Management Controller (MC) is the array component that is responsible for functions related
to the management of the array. The Storage Controller (SC) is responsible for handling Host
IO to the array. Both the MC and SC reside within the same physical controller module.
Some Management Controller functions are:
Managing array user accounts
Managing array logins
Managing array configuration information
20 Troubleshooting HPE MSA 1040/2040 Storage

Other manuals for HP MSA 2040

Related product manuals