To Next PageTo Next Page
Need help?Do you have a question about the HP MSA 2050 and is the answer not in the manual?
Outlines sequential steps for installing enclosures and initial system configuration.
Explains SAS cabling options, including straight-through and fault-tolerant configurations.
Details the correct sequence for powering enclosures on and off, including AC/DC differences.
Lists requirements for data hosts, including operating systems and multi-pathing support.
Describes how to connect servers to storage ports using various cabling configurations.
Details setting up Remote Snap replication between two storage systems.
Covers methods for obtaining and setting IP addresses via DHCP or CLI.
Instructions on accessing the web-based Storage Management Utility (SMU).
Guides on using the SMU to configure and provision the storage system and set up replication.
Presents the basic methodology for locating faults and identifying Field Replaceable Units (FRUs).
Discusses cache behavior and data protection during controller failure events.
Provides procedures for troubleshooting connection faults between hosts and controller ports.
Details troubleshooting steps for faults in controller module expansion port connections.
Covers troubleshooting common issues encountered with Remote Snap replication setup.
Guides on addressing voltage and temperature warnings by checking fans and sensors.
Details how to interpret front panel LED statuses to diagnose faults.
Details how to interpret disk drive LED statuses to diagnose faults.
Details how to interpret host port LED statuses to diagnose faults.
Details how to interpret power supply LED statuses to diagnose faults.
Explains the LEDs on the rear panel of SAN controller modules for FC and iSCSI ports.
Emphasizes adherence to local safety codes and equipment markings for installation.
General