Controller enclosure—rear panel layout 13
MSA 2050 SAN controller module—rear panel components
Figure 5 shows host ports configured with either 8/16 Gb FC or 10GbE iSCSI SFPs. The SFPs look identical. Refer to the
LEDs that apply to the specific configuration of your Converged Network Controller ports.
Figure 5 MSA 2050 SAN controller module face plate (FC or 10GbE iSCSI)
Figure 6 shows Converged Network Controller ports configured with 1 Gb RJ-45 SFPs.
Figure 6 MSA 2050 SAN controller module face plate (1 Gb RJ-45)
NOTE: For
more information about host port configuration, see the topic about configuring host ports within the SMU
Reference Guide or online help.
1 Host ports: used for host connection or replication
[see “Install an SFP transceiver” (page 77)]
2 CLI port (USB - Type B)
3 Service port 2 (used by service personnel only)
4 Reserved for future use
5 Network port
6 Service port 1 (used by service personnel only)
7 Disabled button (used by engineering only)
(Sticker shown covering the opening)
8 SAS expansion port
1 Host ports: used for host connection or replication
[see “Install an SFP transceiver” (page 77)]
2 CLI port (USB - Type B)
3 Service port 2 (used by service personnel only)
4 Reserved for future use
5 Network port
6 Service port 1 (used by service personnel only)
7 Disabled button (used by engineering only)
(Sticker shown covering the opening)
8 SAS expansion port
157
3 4
6
8
2
= FC LEDs
= 10GbE iSCSI LEDs
= 1 Gb iSCSI LEDs (all host ports use 1 Gb RJ-45 SFPs in this figure)
157
3 4
6
8
2
= FC LEDs
To Next Page
Loading...
