HP MSA 2050 - Switch Attach Configurations

30 Connecting hosts
Connecting switch attach configurations
Two servers/two switches
Figure 18 Connecting hosts: switch attach—two servers/two switches
Four servers/multiple switches/SAN fabric
Figure 19 Connecting hosts: switch attach—four servers/multiple switches/SAN fabric
Connecting remote management hosts
The management host directly manages systems out-of-band over an Ethernet network.
1. Connect an RJ-45 Ethernet cable to the network management port on each MSA 2050 controller.
2. Connect the other end of each Ethernet cable to a network that your management host can access (preferably on the
same subnet).
NOTE: Connections to this device must be made with shielded cables—grounded at both ends—with metallic RFI/EMI
connector hoods, in order to maintain compliance with NEBS and FCC Rules and Regulations.
NOTE: Access via HTTPS and SSH is enabled by default, and access via HTTP and Telnet is disabled by default.
6Gb/s
S
S
A
6Gb/s
S
S
A
Server 1 Server 2
Switch A Switch B
MSA 2050 SAN
Server 1 Server 2
SAN
Server 3 Server 4
MSA 2050 SAN