HP OmniBook 500

HP Omnibook 500 Removal and Replacement 2-13
Removing an Expansion SDRAM Module
Removal Procedure
1. Unplug the AC adapter, if present, and remove the battery.
2. From the bottom of the computer, remove the screw from the SDRAM cover, and remove the cover.
3. Release the latches at the sides of the SDRAM module (so that the module’s free edge pops up),
then pull the module out of the connector.
Figure 2-10. Removing an SDRAM Expansion Module
Reassembly Note
•
Carefully insert the edge of the new SDRAM module into the connector at about a 30° angle until
it is fully seated. Then press down on both sides of the module until the latches snap closed.
Screw, M2×3mm