HP OmniBook 500

2-30 Removal and Replacement HP Omnibook 500
Figure 2-21. Removing Bottom Case Components
Installation Procedure
1. Install a new Microsoft Product ID label.
2. Transfer the old serial number label and install a new overlay, or create a new serial number label
using the steps below.
3. Restore the labels on the bottom case, as follows:
•
If the notebook includes a hardware modem mini-PCI card, attach the hardware modem
telecom regulatory label.
•
If the notebook includes a LAN/modem mini-PCI card, attach the LAN/modem telecom
regulatory label.
•
If the notebook is an option code AB2 (for China) or ACQ (for South Africa), add the
appropriate sticker included in the telecom sticker set.
4. Reinstall the bottom case in the unit following the “Reassembly Notes” on page 2-26.
Screws, M2×3mm (3)
Screw, M2×2mm
Screws, M2×5mm (2)