HP OmniBook 6000 Service Manual

2-6 Removal and Replacement HP OmniBook 6000
Removing an SDRAM Module
(User-Replaceable)
The OmniBook 6000 has no SDRAM on its motherboard, but has two slots for that hold two SDRAM
modules. One slot contains a SDRAM module installed at the factory.
Table 2-4. SDRAM Module Replacement Part Numbers
Description Part Number Exchange Part Number
SDRAM module, 32-MB (100 MHz) 1818-7950
SDRAM module, 64-MB (100 MHz) 1818-7951 F1660-69103
SDRAM module, 128-MB (100 MHz) 1818-7952 F1660-69104
SDRAM module, 256-MB (100 MHz) 1818-7953 F1654-69101
Caution
Handle the SDRAM module only by its edges and provide proper grounding, or you might damage
the board by electrostatic discharge.
Required Equipment
• Small Phillips screwdriver.
Removal Procedure
1. Unplug the ac adapter, if present, and remove the battery. Remove the secondary battery if one is
installed.
2. Turn the unit bottom-side up, loosen the screw holding the SDRAM cover (the cover retains the
screw), and remove the cover.
3. Release the two latches at the sides of the SDRAM module, so the free edge of the board pops up.
4. Pull the board out of the connector.
Figure 2-5. Removing a SDRAM Module
Reassembly Notes
• Gently press the SDRAM module into the connector at about a 30° angle, until it is fully inserted.
Then press down on both sides until the latches snap closed.

HP OmniBook 6000 Specifications

General

Brand	HP
Model	OmniBook 6000
Category	Laptop
Language	English