HP OmniBook 6000 Service Manual

2-12 Removal and Replacement HP OmniBook 6000
Replacing Small Parts
(User-Replaceable)
The user can replace the following small parts.
Table 2-7. Replacing Small Parts (User-Replaceable)
Part Replacement Procedure
Cap, pointing stick
Pull the cap off the pointing stick.
Bumpers, display (on
display bezel)
Insert a small flat-blade screwdriver under the bumper and pry it loose. To replace,
firmly press the adhesive side of the bumper into the recess.
Cover, mini-PCI
On the bottom of the computer, loosen the screw in the mini-PCI cover (the cover
retains the screw) and remove the cover.
Cover, SDRAM
On the bottom of the computer, loosen the screw in the SDRAM module cover (the
cover retains the screw) and remove the cover.
Covers, screw (on
display bezel)
Insert a small flat-blade screwdriver under the cover and pry it loose. To replace,
firmly press the adhesive side of the cover into the recess.
Covers, left/right
corner
From the bottom of the computer, remove the screws holding the corner covers, then
remove the covers.
Feet, rubber (on
bottom of unit)
Insert a small flat-blade screwdriver under the foot and pry it loose. To replace, firmly
press the adhesive side of the foot into the recess.

HP OmniBook 6000 Specifications

General

Brand	HP
Model	OmniBook 6000
Category	Laptop
Language	English