To Next Page

To Previous Page

2-7

Installing the Switch 2650

Installation Procedures

Installing the Switch 2650

Removing the mini-GBICs:

Note You should disconnect the network cable from the mini-GBIC before removing

it from the switch.

Depending on when you purchased your HP Procurve mini-GBIC, it may have

either of three different release mechanisms: a plastic tab on the bottom of

the mini-GBIC, a plastic collar around the mini-GBIC, or a wire bail.

To remove the mini-GBICs that have the plastic or plastic collar, push the tab

or collar toward the switch until you see the mini-GBIC release from the switch

(you can see it move outward slightly), and then pull it from the slot.

To remove the mini-GBICs that have the wire bail, lower the bail until it is

approximately horizontal, and then using the bail, pull the mini-GBIC from the

slot.

Other manuals for HP ProCurve 2650

Questions and Answers:

Need help?

Do you have a question about the HP ProCurve 2650 and is the answer not in the manual?

General