To Next Page

To Previous Page

2-15

Installing the Switch 2650

Installation Procedures

Installing the Switch 2650

Horizontal Surface Mounting

Place the switch on a table or other horizontal surface. The switch comes with

rubber feet in the accessory kit that can be used to help keep the switch from

sliding on the surface.

Attach the rubber feet to the four corners on the bottom of the switch within

the embossed angled lines. Use a sturdy surface in an uncluttered area. You

may want to secure the networking cables and switch power cord to the table

leg or other part of the surface structure to help prevent tripping over the

cords.

Caution Make sure the air flow is not restricted around the sides and back of the switch.

5. Connect the Switch to a Power Source

1. Plug the included power cord into the switch’s power connector and into

a nearby AC power source.

2. Re-check the LEDs during self test. See “LED Behavior” on page 2-9.

Other manuals for HP ProCurve 2650

Questions and Answers:

Need help?

Do you have a question about the HP ProCurve 2650 and is the answer not in the manual?

General