96
Enhancements
Release M.10.22 Enhancements
To display information about ports with loop protection, enter this command.
Figure 28. Example of Show Loop Protect Display
[trap <loop-detected>]
Allows you to configure loop protection traps The “loop-detected” trap indicates
that a loop was detected on a port.
[disable-timer <0-604800>]
How long (in seconds) a port is disabled when a loop has been detected. A value
of zero disables the auto re-enable functionality.
Default: Timer is disabled
[transmit-interval <1-10>]
Allows you to configure the time in seconds between the transmission of loop
protection packets.
Default: 5 seconds
Syntax: show loop-protect <port-list>
Displays the loop protection status. If no ports are specified, the information is
displayed only for the ports that have loop protection enabled.
ProCurve(config)# show loop-protect 1-4
Status and Counters - Loop Protection Information
Transmit Interval (sec) : 5
Port Disable Timer (sec) : 5
Loop Detected Trap : Enabled
Loop Loop Loop Time Rx Port
Port Protection Detected Count Since Last Loop Action Status
---- ----------- --------- ---------- ---------------- ------------ --------
1 Yes No 0 send-disable Up
2 Yes No 0 send-disable Up
3 Yes No 0 send-disable Up
4 Yes No 0 send-disable Up
To Next Page
Loading...
Need help?
General