133
Enhancements
Release M.10.43 Enhancements
An example of the show ip source-lockdown status command output is shown in Figure 20. Note that
the operational status of all switch ports is displayed. This information indicates whether or not
dynamic IP lockdown is supported on a port.
Figure 20. Example of show ip source-lockdown status Command Output
Displaying the Static Configuration of IP-to-MAC Bindings
To display the static configurations of IP-to-MAC bindings stored in the DHCP lease database, enter
the show ip source-lockdown bindings command.
An example of the show ip source-lockdown bindings command output is shown in Figure 21.
Syntax: show ip source-lockdown bindings [<port-number>]
port-number (Optional) Specifies the port number on which
source IP-to-MAC address and VLAN bindings
are configured in the DHCP lease database.
ProCurve(config)# show ip source-lockdown status
Dynamic IP Lockdown (DIPLD) Information
Global State: Enabled
Port Operational State
-------- ------------------
A1 Active
A2 Not in DHCP Snooping vlan
A3 Disabled
A4 Disabled
A5 Trusted port, Not in DHCP Snooping vlan
. . . . . . . . . . . . . ..
To Next Page
Loading...
Need help?
General