Configuring the Switch Modules using the Menu-driven Interface
Saving Settings to a TFTP Server
After completing the final configuration for the switch module, HP highly recommends that
you save the switch module configuration file to TFTP server storage.
To save the switch module configuration file to a TFTP server:
1. Highlight Save Settings to TFTP Server on the Switch Utilities menu.
2. Press the Enter key. The following screen is displayed.
3. Type the IP address of the TFTP server in the Server IP Address field.
4. Type the port number of the TFTP server you wish to connect to in the Server TFTP
Port Number field.
5. Type the location of the switch module configuration file on the TFTP server in the
Path\Filename field.
6. Highlight APPLY.
7. Press the Enter key.
8. Highlight START.
9. Press the Enter key to initiate the file transfer.
IMPORTANT: To save the configuration settings permanently, you must enter them into NVRAM
using the Save Changes option on the main menu. Refer to the “Saving Changes” section earlier
in this chapter.
2-62 HP ProLiant BL e-Class C-GbE Interconnect Switch Menu-driven Interface Reference Guide
HP CONFIDENTIAL Codename: DeLorean Part Number: 322858-001 Last Saved On: 2/4/03 11:56 AM
To Next Page
Loading...
