Overview
Accessing the Switch Modules
After the Integrated Administrator is configured, you can access and configure the switch
modules through the Integrated Administrator software. For information on how to configure
the Integrated Administrator, refer to the “Configuring the Integrated Administrator” section
in the HP ProLiant BL e-Class C-GbE Interconnect Switch User Guide.
To access the switch modules from the Integrated Administrator command line interface, use
one of the following methods:
•
•
If you have already logged into the Integrated Administrator as the “Administrator,” you
can connect to either switch module console using one of the following commands:
connect switch a to access Switch A
or
connect switch b to access Switch B
If you have not logged on to the Integrated Administrator, you can use one of two special
logon accounts to access the switch module consoles directly, depending on whether you
want to access Switch A or Switch B. At the login prompt type in both the user name and
password as either:
switcha
or
switchb
The logon screen for Switch A or Switch B will now be displayed.
IMPORTANT: The interconnect switch does not have any initial user names or passwords set. HP
recommends that after logging on, you create at least one Root-level user as the switch administrator.
(Refer to Table 2-1 in Chapter 2 for an explanation of user privileges.) If you forget your password after
it has been set up, call HP Customer Support for assistance.
1-2 HP ProLiant BL e-Class C-GbE Interconnect Switch Menu-driven Interface Reference Guide
HP CONFIDENTIAL Codename: DeLorean Part Number: 322858-001 Last Saved On: 2/4/03 11:53 AM
To Next Page
Loading...
