Configuring the Switch Modules using the Menu-driven Interface
Rebooting the Switch Module
The switch module reboot options are:
•
•
•
•
Reboot—Restarts the switch module. Any configuration settings not saved using Save
Changes from the main menu are lost. The switch module configuration is restored to the
last configuration saved in NVRAM.
Save Configuration & Reboot—Saves the configuration to NVRAM (identical to using
Save Changes) and then restarts the switch module.
Reboot & Load Factory Default Configuration—Restarts the switch module using the
default factory configuration. All user-defined configuration data is lost.
Reboot & Load Factory Default Configuration Except IP Address—Restarts the
switch module using the default factory configuration, except the user-configured IP
address, which is retained. All other configuration data is lost. If you want your IP
address to default from DHCP or BOOTP, do not choose this option.
NOTE: Refer to Appendix C in the HP ProLiant e-Class C-GbE Interconnect Switch User Guide for a
list of factory default settings.
To reboot the switch module from the console:
1. Highlight Reboot on the main menu.
2. Press the Enter key. The following screen is displayed.
3. Highlight the appropriate selection.
HP ProLiant BL e-Class C-GbE Interconnect Switch Menu-driven Interface Reference Guide 2-65
HP CONFIDENTIAL Codename: DeLorean Part Number: 322858-001 Last Saved On: 2/4/03 11:56 AM
To Next Page
Loading...
