Removal and replacement procedures 50
7.
Disconnect the capacitor pack cable from the cache module.
8. Remove the capacitor pack.
To replace the component, reverse the removal procedure.
Capacitor pack holder
To remove the component:
1. Power down the server (on page 27).
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Do one of the following:
o Extend the server from the rack (on page 27).
o Remove the server from the rack (on page 28).
4. Remove the access panel ("Access panel" on page 29).
5. Remove the processor air baffle ("Processor air baffle" on page 30).
6. Remove the capacitor pack ("Capacitor pack" on page 49).
To Next Page
Loading...
