Removal and replacement procedures 44
Front video adapter
Remove the component as indicated.
CAUTION: Be sure to connect the video adapter to the video connector, and not to the USB
connector.
To replace the component, reverse the removal procedure.
FlexibleLOM option
WARNING: To reduce the risk of personal injury, electric shock, or damage to the equipment,
remove the power cord to remove power from the server. The front panel Power On/Standby
button does not completely shut off system power. Portions of the power supply and some internal
circuitry remain active until AC power is removed.
1. Power down the server (on page 27).
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Remove any attached network cables.
4. Do one of the following:
o Extend the server from the rack (on page 27).
o Remove the server from the rack (on page 28).
5. Remove the access panel ("Access panel" on page 29).
6. Remove the processor air baffle ("Processor air baffle" on page 30).
7. Remove the PCI riser cage ("PCI riser cage" on page 45).
8. Loosen the thumbscrew on the FlexibleLOM.
To Next Page
Loading...
