Removal and replacement procedures 54
a.
Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Do one of the following:
o Extend the server from the rack (on page 27).
o Remove the server from the rack (on page 28).
4. Remove the access panel ("Access panel" on page 29).
5. Remove the processor air baffle ("Processor air baffle" on page 30).
6. Remove the heatsink:
a. Loosen one pair of diagonally opposite screws halfway, and then loosen the other pair of screws.
b. Completely loosen all screws in the same sequence.
c. Remove the heatsink from the processor backplate.
To replace the component:
1. Clean the old thermal grease from the top of the processor with the alcohol swab. Allow the alcohol to
evaporate before continuing.
2. Remove the thermal interface protective cover from the heatsink.
3. Install the heatsink:
To Next Page
Loading...
