Setup 28
b.
To secure the cable tie, loop the end through the plastic buckle on the other end.
c. To secure the power cord, repeat steps a and b, using the other cable tie.
When multiple cable ties are used in the same rack, stagger the cable tie location, so that the ties are
adjacent to each other when viewed from top to bottom. This positioning will enable the rack rail to slide
easily in and out of the rack.
Powering on and selecting boot options
1. Connect the Ethernet cable.
2. Press the Power On/Standby button.
3. During the initial boot:
o To modify the server configuration ROM default settings, press F9 when prompted from the start up
sequence to enter the RBSU. By default, RBSU runs in the English language.
To Next Page
Loading...
