HP ProLiant DL320e Gen8 v2 User Manual

Hardware options installation 47
General DIMM slot population guidelines
• The server supports two memory channels with two DIMM slots per channel:
o Memory channel 1 consists of the two DIMMs that are closest to the processor.
o Memory channel 2 consists of the two DIMMs that are located farthest from the processor.
• White DIMM slots denote the first slot of a channel (3-A, 1-B).
• The server supports up to 32 GB of system memory using four 8 GB 1600 MT/s ECC UDIMMs.
• When installing DIMMs:
o Populate the DIMM slots in this sequence: 3-A, 1-B, 4-C, 2-D.
o Use only HP qualified DIMMs.
• The server does not support RDIMMs and LRDIMMs.
• The minimum DIMM requirement to make this server bootable is a DIMM in slot 3-A.
• For DIMM spare replacement, install the DIMMs per slot number as instructed by the system software.
For detailed memory configuration rules and guidelines, use the Online DDR3 Memory Configuration Tool
on the HP website (http://www.hp.com/go/ddr3memory-configurator).
Installing a DIMM
1. Power down the server (on page 14).
2. Remove the power from the server:
a. Disconnect the power cord from the power source.
b. Disconnect the power cord from the server.
3. Do one of the following:
o Extend the server from the rack (on page 14).
o Remove the server from the rack (on page 16).
4. Remove the access panel (on page 17).
5. Remove the air baffle (on page 18).
6. Open the DIMM slot latches.

HP ProLiant DL320e Gen8 v2 Specifications

General

Processor	Intel Xeon E3-1200 v3 series
Processor Sockets	1
Memory	Up to 32GB
Memory Slots	4
Form Factor	1U Rack
Memory Type	DDR3 UDIMM
Storage	Up to 4 LFF or 8 SFF drives
RAID Support	HP Dynamic Smart Array B120i
Expansion Slots	1 PCIe 3.0
Management	HP iLO